+8613432040874

Leave Your Message
Low Power Bluetooth BLE5.0 Lamp Control Module Mesh Networking Transparent Transmission Module TB-03F-Kit/Development Board -80697
Products

Low Power Bluetooth BLE5.0 Lamp Control Module Mesh Networking Transparent Transmission Module TB-03F-Kit/Development Board -80697

TB-03 TB-03F Bluetooth-compatible BLE 5.0 Module Light Control Development Board

    product detail

     The TB-03F intelligent lighting module is a Bluetooth-compatible module designed based on the TLSR8253 chip and compliant with BT 5.0 low-power Tmall Genie Mesh; the module supports direct control by Tmall Genie, and has the Bluetooth-compatible mesh networking function; For star network communication, Bluetooth-compatible broadcast is used for communication, which can ensure timely response in the case of multiple devices. This module is used in intelligent light control, which can meet the requirements of low power consumption, low delay, and short-range wireless data communication.
    Parameter:
    Wireless standard: Bluetooth-compatible 5.0
    Frequency range: 2400 ~ 2483.5MHz
    Maximum transmit power: maximum 10dBm
    Receiving sensitivity: -93dBm±2
    Interface: GPIO/PWM/SPI/ADC/I2S
    Working temperature: -40°C ~ 85 °C
    Storage environment: -40 °C ~ 125 °C, <90%RH
    Power supply range: power supply voltage 2.7V~ 3.6V, power supply current ≥50mA
    Transmission distance: Outdoor open viewing distance: 80 meters -150 meters

    Pin description:

    RST: reset active low
    PC4: PWM2 output/UART_CTS, PWM0 reverse output/SAR ADC input/GPIO PC4
    SWS: Single-wire slave/UART_RTS/GPIO PA7
    PC3: PWM1 output/UART_RX/I2C serial clock/32kHz crystal input (optional)/GPIO PC3
    PD7: GPIO PD7/SPI clock (I2C_SCK)
    PB7: SPI_D0 data output/UART_RX/SAR ADC input/GPIO PB7
    PB6: SPI_DI data input (I2C_SDA), UART_RTS/SAR ADC input/GPIO PB6
    3V3: power supply
    NC: empty pin
    PA1: GPIO PA1/ I2S_clock
    PC2: PWM0 output/I2C serial data/32kHz crystal output (optional)/GPIO PC2
    PB4: PWM4 output/SAR ADC input/GPIO PB4
    PB5: PWM5 output/SAR ADC input/GPIO PB5
    NC.: empty pin
    GND: Ground
    PD2: GPIO PD2/PWM3 output/SPI chip select (active low)/I2S_LR 17 PD3 GPIO
    PD3/PWM1 reverse output /I2S_SDI
    PD4: GPIO PD4/single-wire slave SWM/PWM2 reverse output/I2S_SD0
    PCI: I2C_CLK/PBI1 reverse output/PWMO output/GPIO PCI
    PC0: I2C_SDA/PWM4 reverse output/UART_RTS/GPIO PCO
    PA0: UART_RX/GPIO PAO, PWMO reverse call output
    PB1: UART_TX/GPIO PB1/PWM4 output/SAR ADC input